How to fix no display on my ICM Controls Thermostat?
If your ICM Controls Thermostat display is blank, here's what to check: * **For hardwired installations:** Ensure that there is 24 VAC present at the thermostat. The display will be blank if there is no 24 VAC. * **For battery installations:** Make sure the batteries are not drained and are installed correctly. A blank display indicates drained or incorrectly installed batteries.
What to do if my ICM Controls SC 2210 displays 'filter'?
The 'filter' display on your ICM Controls Thermostat indicates that the fan run time has exceeded the filter check time set in the configuration. To reset the counter to zero and clear the filter warning, simultaneously press the up and down buttons for 5 seconds.
Why does the fan run continuously on my ICM Controls Thermostat?
If the fan runs continuously on your ICM Controls Thermostat, check the fan On/Auto switch. If it's in the 'ON' position, the indoor fan will run continuously. Switch it to 'Auto' for normal operation.
How to fix incorrect room temperature on my ICM Controls SC 2210?
If the room temperature displayed on your ICM Controls Thermostat is incorrect: * Verify that the wall hole behind the thermostat is plugged with putty or insulation to prevent drafts. * Calibrate the thermostat.
What to do if the system fan does not come on properly on my ICM Controls Thermostat?
If the system fan on your ICM Controls Thermostat is not working correctly, verify that the wiring is correct.
How to stop ICM Controls SC 2210 Thermostat from turning on and off too frequently?
To address frequent on/off cycling of your ICM Controls Thermostat, adjust the temperature differential.
What does 'ROOM' display mean on my ICM Controls SC 2210 Thermostat?
The 'ROOM' display on your ICM Controls Thermostat indicates that the room temperature offset is not set to zero.
What to do if there is a problem not listed for ICM Controls Thermostat?
If you are experiencing an issue with your ICM Controls Thermostat that is not listed, press the Reset button once. This will refresh the display and reset the anti-short cycle timing to zero.
How to adjust auxiliary heat on ICM Controls Thermostat to come on sooner?
If the auxiliary heat on your ICM Controls Thermostat is not activating soon enough, adjust the differential for 2nd and 3rd stage heating if required.
Steps to safely disconnect and remove the old thermostat from the wall.
Detailed instructions for mounting the new thermostat and connecting wires.
Details on setting temperature scales, differentials, and other system parameters.
Procedure to verify the thermostat's cooling operation and settings.
Procedure to verify the thermostat's heating operation and settings.
Procedure to verify emergency heat function and auxiliary heat activation.
Procedure to test the fan operation in both Auto and On modes.
General| Type | Non-programmable Thermostat |
|---|---|
| Display | Digital |
| Stages | 1 Heat/1 Cool |
| Voltage | 24 VAC |
| Programmable | No |
| Backlight | Yes |
| Temperature Range | 45°F to 90°F (7 to 32°C) |
To Next Page