21
8. Maximum Heat Setpoint
(55°F to 90°F) (13°C to 32°C)
Adjust to control the maximum Heat set temperature allowed.
Press the or button to select.
Press the
SW6 button
to advance to the next screen.
FILTER
DIFF
ROOM
SET
REMOTE
FILTER
DIFF
ROOM
SET
REMOTE
FILTER
DIFF
ROOM
SET
REMOTE
9. Room temperature offset
(+9°F to -9°F) (+4.5°C to -4.5°C)
Adjust to calibrate displayed room temperature to match actual room temperature.
Note: When not set to 0, ROOM will display
Press the or button to select.
Press the
SW6 button
to advance to the next screen.
FILTER
DIFF
ROOM
SET
REMOTE
10. Maximum compressor cycles allowed per hour (-, 2-6)
- = as many as needed, and 2-6 = maximum cycles/hour
Press the or button to select.
Press the
SW6 button
to advance to the next screen.
12. Status Indicator Light (Lt 0, 1, 2)
0 = Status indicator never on
1 = Status indicator on with first stage
2 = Status indicator on with second stage
Press the or button to select.
Note: Red light indicates heating cycle and green light indicates cooling cycle.
Slide the Mode switch to Heat or Cool to exit configuration.
FILTER
DIFF
ROOM
SET
REMOTE
FILTER
DIFF
ROOM
SET
REMOTE
(500 Hours)
11. Filter Check time (300-800, – – –)
Set Fan Run Time (in hours) when Check Filter is displayed or set to – – – to disable.
Press the or button to select.
Note: To reset filter counter to zero and clear filter warning, press the
and buttons simultaneously for 5 seconds.
Press the
SW6
button to advance to the next screen.
To Next Page
Loading...
Need help?
General
