25
Programming (continued)
• Set time is displayed
8. Press the or button to change set time.
9. Press the button to advance to the next screen.
Note: Transitions required after 11:59 PM must be programmed in the
next day’s MORN period.
• Heat temperature is displayed (50°F to 90°F)
10. Press the or button to adjust heat set temperature.
11. Press the button to advance to the next screen.
• Cool temperature is displayed (45°F to 85°F)
12. Press the or button to adjust cool set temperature.
13. Press the button to advance to the next screen.
Repeat steps 1-13 to program each day of the week individually or use the
Simpleset
®
feature (see Page 26) to program every day the same as Monday.
When programming is complete, slide the System switch to Heat or Cool to exit Programming Mode. Your
program schedule will be saved in memory and you will be returned to the Off mode.
To Next Page
Loading...
Need help?
General
