BE CAREFUL! The transceiver will become hot when
operating continuously for long periods.
USE the specied microphone only. Other microphones have
different pin assignments and may damage the transceiver.
Place the transceiver in a secure place to avoid inadvertent use by
children.
KEEP the transceiver away from the heavy rain, and never
immerse it in the water. The transceiver meets IP54* requirements
for dust-protection and splash resistance. However, once the
transceiver has been dropped, dust protection and splash
resistance cannot be guaranteed due to the fact that the transceiver
may be cracked, or the waterproof seal damaged, and so on.
*Only when the supplied microphone is attached.
Icom, Icom Inc. and Icom logo are registered trademarks of Icom
Incorporated (Japan) in Japan, the United States, the United Kingdom,
Germany, France, Spain, Russia, Australia, New Zealand, and/or other
countries.
The Bluetooth word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by Icom inc. is under license.
All other products or brands are registered trademarks or trademarks of their
respective holders.
ii
PRECAUTIONS
R WARNING! NEVER connect the transceiver to an AC
outlet. This may pose a re hazard or result in an electric shock.
R WARNING! NEVER connect the transceiver to a power
source of more than 31.5 V DC. This could damage the transceiver.
R WARNING! NEVER cut the DC power cable between
the DC plug and fuse holder. If an incorrect connection is made
after cutting, the transceiver might be damaged.
R WARNING! NEVER place the transceiver where normal
operation of the vehicle may be hindered or where it could cause
bodily injury.
CAUTION: NEVER expose the transceiver to rain, snow or
any liquids.
DO NOT operate or place the transceiver in areas with
temperatures below –30°C (–22°F) or above +60°C (+140°F), or in
areas subject to direct sunlight, such as the dashboard.
DO NOT operate the transceiver without running the vehicle’s
engine. The vehicle’s battery will quickly run out when the
transceiver transmits while the vehicle’s engine is OFF.
DO NOT place the transceiver in excessively dusty
environments.
DO NOT place the transceiver against walls. Otherwise heat
dissipation will be obstructed.
DO NOT use harsh solvents such as benzine or alcohol when
cleaning, as they damage the transceiver surfaces.
CAUTION: In Canada, use of 8.33 kHz Channel Spacing of this
radio is strictly prohibited and shall not be used.
To Next Page
Loading...
Need help?
General
