8/19/2011 1
What is Covered in this Guide
This guide provides simplified step by step instructions for programming your FR5000/FR6000 repeater. The
programming information covers IDAS 6.25kHz digital programming, including IDAS trunking. It covers repeater
operation only, though the repeater can be used as a base station.
IDAS (Icom Digital Advanced System) is a digital and analog land mobile radio system, using the NXDN™
6.25kHz digital modulation and common air interface protocol.
Before You Start Programming
Check that you have the following:
CS-FR5000 cloning software, latest version
Latest firmware loaded in the Radios, Repeaters, and Trunking Controllers (if applicable)
Repeater power supply
Cloning cable OPC-1122/U
UC-FR5000 Trunking Controller Boards (for trunking applications)
Applicable Models
This Guide applies to the FR5000/FR6000 repeaters only.
To Next Page
Loading...
Need help?
General
