10 © June 2011 Icom America
To Make an Emergency Call
To call a specific radio (or dispatch):
Press and hold the assigned Emergency Key for 2 seconds. The RX radio beeps as it forewarns you of the
upcoming emergency call.
The radio diverts to the Emergency channel (as assigned in ATR) and sends the 5- tone signal.
RX Radio:
Memory Ch
5Tone Signaling » Form
Set to EIA
5Tone Signaling » RX C.No
Set to 1. Points to 1
st
line in the RX Code CH window: the
RX Radio’s Emergency RX Code
RX Code CH (under 5 Tone)
Line 1 » RX Code
RX radio Emergency Code (from Memory Ch
window…usually the same for all radios)
Line 1 » ID Dec
Set to ON. This allows the radio to show the TX radio ID.
Line 1 » Text
Enter emergency text to display on dispatch radio, if
desired.
RX Code Setting (under 5 Tone)
Timer » ID Decode
Set to 1.6
TX Code Setting (under 5 Tone)
Timer » Displayed Digit
Enter the digits you want displayed. For example: Send
98765, but if you only want 765
to show on this radios
display, enter “345”. Now the last 3 digits of any 5 tone ID
To Next Page
Loading...
