Icom IC-910H - Programming Kill;Stun;Revive in 5-Tone

© June 2011 Icom America 11
Programming Kill/Stun/Revive in 5-Tone
This procedure enables you to kill or stun a selected radio. Revive is also available on some models. A stunned
radio can be revived by cycling power and entering a password; a killed radio must be re-cloned to be revived.
The following instructions assume that frequencies, tones, and squelch are set and the radios are in PMR mode
(found in the Menu bar under Model). Additionally, the Auto Reset Timer must be enabled (Memory CH) and a
value entered (Common -> Common). These instructions apply to all Icom radios with PMR capability.
TX radio
Memory Ch
Field
Setting / Description
CH Mute
Mute options depend on radio model:
Cont (not muted)
Or (not muted)
5Tone Signaling
»
Form
Set to EIA
5Tone Signaling » STN
Set to 1. Points to 1
st
line in the TX Code CH window: target
Radio’s 5 Tone code.
TX Code CH (under 5 Tone):
Field
Setting / Description
Line 1 » Text
Enter text for target radios, such as Kill or Stun Unit XXX
Lines 2, 3 etc. » Text
Enter text for any additional target radios
Unused lines » Sel
Set all unused lines to
OFF
so that you don’t have to scroll
through them when selecting a Code.
Key and Display (under Common)
Field
Setting / Description
Key » P0-P3
Assign a key (right-click Conventional field to access
menu) for the following functions:
TX Code CH Select— Enters the Code Select mode so
that you can select a target radio from the TX Code
Channel list.
TX Code CH Up—Allows you to scroll through the target
radio list and select a radio. (As an alternative, you can
also use the Up/Down keys to scroll.)
Call—Sends the 5-tone signal and Kill/Stun command to the
target radio.