Icom IC-910H - 5 Tone TX Code Setting Window

© June 2011 Icom America 21
5Tone TX Code Setting Window
Field
Description
Long Tone(Sec)
Sets the time period for the 1st digit code emission length when
the long tone function is specified in 5Tone Signaling-L for a
repeater, station or ID code in Zone screen.
Link R(Sec)
Amount of time between when the radio begins transmitting and
the first ID code digit is sent out.
Link 1(Sec)
Amount of time between each digit of the 5 tone code
Link 2(Sec)
Amount of time between each digit of the 5 tone code.
Lead out Delay(Sec)
Amount of time between the transmission of the last 5 tone digit
and the end of transmission.
ABC Decode(Sec)
The amount of time the radio waits to decode before it transmits
an answer back call code.
Displayed Digit
Determines the number of digits of the 5 tone ID that are shown
on the radio display.
PTT Call at Inaudible
When set to ON, the PTT button becomes active regardless of
the mute state.
Group
The decoder accepts this code regardless of the code
programmed into the radio.
Repeat
Used when the same codes are repeated. (e.g. 11111 ->
1E1E1)
Link2
Emits this code instead of no modulation between the station
and ID codes.