9
BASIC MANUAL
5
HEADSET CONNECTION
Transceivers with the built-in Bluetooth unit
can operate with Bluetooth headsets.
The communication range of Bluetooth is
approximately 10 meters (33 ft).
NOTE:
• The Bluetooth communication range
may vary, depending on the environment
where you operate the device.
D Electromagnetic Interference
When you use a Bluetooth device, pay
attention to the following:
Bluetooth devices operate in the 2.4 GHz
band. The 2.4 GHz band is also used
by other devices, such as Wireless LAN
products, microwave ovens, RFID systems,
amateur radio stations, and so on.
When using this device near such devices,
interference may occur, causing a decrease
in communication speed, and an unstable
connection.
In such cases, use this device away from
the other devices, or stop using those
devices.
D Pairing with a device
You can pair maximum of 4 Bluetooth
headsets to the transceiver.
L These instructions describe pairing with
the VS-3 Bluetooth
®
headset, as an
example.
1. Turning ON the transceiver’s
Bluetooth function
1. Push [FUNC], and then hold down
[ENT]/[SET] for 1 second to enter the
Set mode.
2. Select “BT SET,” and then push
[ENT]/[SET].
3. Select “ON,” and then push [ENT]/
[SET].
4. Push [CLR]/[HOME] to exit the Set
mode.
2. Entering the VS-3 Pairing mode
Refer to the VS-3’s instruction manual for
details.
3. Pairing and connecting the
Bluetooth headset
1. Push [FUNC], and then hold down
[ENT]/[SET] for 1 second to enter the
Set mode.
2. Select “PAIRING,” and then push
[ENT]/[SET].
BT SET > PAIRING
• The transceiver searches for a headset.
L Push [CLR] to cancel searching.
• “SUCCESS” and “
” is displayed if the
headset or device is correctly connected.
3. Push [CLR]/[HOME] twice to exit the
Set mode.
Bluetooth
®
Bluetooth headset
(Example:
Optional VS-3)
■ Using a Bluetooth
®
headset
(For only transceivers with the built-in Bluetooth unit)
To Next Page
Loading...
Need help?
General
