Icom IC-A16 - Frequency Adjustments; Transmit Adjustments

10
5
HEADSET CONNECTION
5
BASIC MANUAL
7
10
15
18
8
13
11
16
9
14
6
12
17
1
4
2
3
D Disconnecting a paired device
You can disconnect a paired Bluetooth
device if it is not being used.
1. Push [FUNC], and then hold down
[ENT]/[SET] for 1 second to enter the
Set mode.
2. Select “DISCON,” and then push
[ENT]/[SET].
BT SET > DISCON
• “SUCCESS” is displayed and the
headset is disconnected.
3. Push [CLR]/[HOME] twice to exit the
Set mode.
D Unpairing a device
Before unpairing a connected headset or
device, disconnect it by following the steps
shown to the left.
1. Push [FUNC], and then hold down
[ENT]/[SET] for 1 second to enter the
Set mode.
2. Select “CONNECT,” and then push
[ENT]/[SET].
BT SET > CONNECT
• A paired deviceʼs name is displayed.
L Push [MR]/[MW] to display the
Bluetooth device address.
L Push [∫] or [√] to select other paired
headsets, if necessary.
3. Push [FUNC], and then push
[CLR]/[HOME].
• “DELETE?” is displayed.
4. Push [ENT]/[SET].
5. Push [CLR]/[HOME] twice to exit the
Set mode.
■ Using a wired headset
Connect your headset through the optional OPC-2401 headset adapter.
OPC-2401
PTT switch (User supplied, if necessary)
Use a PTT switch with a 3.5 mm (1/8 inch) plug.
Headset
(User supplied)