EasyManuals Logo

Icom IC-A16 Basic Manual

Icom IC-A16
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
ii
1
7
4
10
15
18
2
8
13
5
11
16
3
9
14
6
12
17
BASIC MANUAL
Precautions
R DANGER! NEVER use or charge Icom
battery packs with non-Icom transceivers
or non-Icom chargers. Only Icom battery
packs are tested and approved for use with
Icom transceivers or charged with Icom
chargers. Using third-party or counterfeit
battery packs or chargers may cause
smoke, re, or cause the battery to burst.
R WARNING! NEVER hold the
transceiver so that the antenna is very
close to, or touching exposed parts of the
body, especially the face or eyes, while
transmitting.
R WARNING! NEVER operate the
transceiver with a headset or other
audio accessories at high volume levels.
The continuous high volume operation
may cause a ringing in your ears. If you
experience the ringing, reduce the volume
level or discontinue use.
CAUTION: DO NOT short the terminals of
the battery pack. Shorting may occur if the
terminals touch metal objects such as a
key, so be careful when placing the battery
packs (or the transceiver) in bags, and so
on. Carry them so that shorting cannot
occur with metal objects. Shorting may
damage not only the battery pack, but also
the transceiver.
CAUTION: DO NOT use harsh solvents
such as Benzine or alcohol when cleaning.
This could damage the equipment
surfaces. If the surface becomes dusty or
dirty, wipe it clean with a soft, dry cloth.
CAUTION: DO NOT place or leave
the transceiver in excessively dusty
environments. This could damage the
transceiver.
DO NOT place or leave the transceiver in
direct sunlight or in areas outside of the
specied temperature range:
IC-A16: –10°C (–14˚F) ~ +60°C (+140˚F)
IC-A16E: –20°C ~ +55°C
BE CAREFUL! The transceiver meets:
IP67/IP54* requirements (IP67: Dust
tight and waterproof protection, IP54:
Dust protection and splash resistance).
However, once the transceiver has been
dropped, dust and waterproof protections
cannot be guaranteed due to the fact that
the transceiver may be cracked, or the
waterproof seal damaged, and so on.
* Only when the jack cover or the optional
speaker microphone is attached.
This transceiver is NOT approved
for use by the general population in
an uncontrolled environment. This
transceiver is restricted to occupational
use, work related operations only where
the transceiver operator must have the
knowledge to control.
This equipment is not suitable for use in
locations where children are likely to be
present.
CAUTION: In Canada, use of 8.33 kHz
Channel Spacing of this radio is strictly
prohibited and shall not be used.
Icom, Icom Inc. and Icom logo are registered
trademarks of Icom Incorporated
(Japan) in Japan, the United States, the United
Kingdom, Germany, France, Spain, Russia,
Australia, New Zealand, and/or other countries.
The Bluetooth
®
word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Icom Inc. is under license.
Other trademarks and trade names are those of their
respective owners.
3M, PELTOR, and WS are trademarks of 3M Company.
All other products or brands are registered
trademarks or trademarks of their respective holders.
Icom is not responsible for the destruction,
damage to, or performance of any Icom or
non-Icom equipment, if the malfunction is
because of:
Force majeure, including, but not limited to,
res, earthquakes, storms, oods, lightning,
other natural disasters, disturbances, riots,
war, or radioactive contamination.
The use of Icom transceivers with any
equipment that is not manufactured or
approved by Icom.

Other manuals for Icom IC-A16

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-A16 and is the answer not in the manual?

Icom IC-A16 Specifications

General IconGeneral
Channel Spacing8.33 kHz/25 kHz
Number of Memory Channels200 channels
Antenna Impedance50 Ω
WaterproofIP67
DisplayLCD
Frequency Range118.000–136.9916 MHz
Output Power6 W (PEP), 1.8 W (carrier)
WeightApprox. 300 g (with standard battery)
Power Supply Requirement7.2 V DC
Current Drain (Transmit)1.5 A
ModeAM
Channels200
Voltage7.2V

Related product manuals