Icom IC-F3000 Series - BASIC OPERATION; Powering On and Battery Type Selection

12
3
"!3)#/0%2!4)/.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
N4URNINGPOWER/.
Prior to using the transceiver for the first
time, the battery pack must be fully charged
for optimum life and operation. (p. 23)
±Rotate [VOL] to turn power ON.
D Battery type selection
The battery type must be selected according to the battery pack or
case when it is changed, but only the first time it is used.
Check the battery type before you begin the selection procedure.
One to three beep(s) sound in sequence, so you must repeat the
steps until the number of beeps matches your battery type.
For example, if your battery type is a Li-ion battery pack, you must
repeat the procedure until 1 beep is heard.
q Set
;2/4!29 3%,%#4/2= TO ANY
channel other than Channel 16.
w Rotate [VOL] to turn the transceiv-
er power OFF.
e While pushing and holding [PTT],
rotate [VOL] to turn the power ON.
 s9OU SHOULD HOLD ;044= UNTIL THE
beeps sound. (It takes approximate-
ly 5 seconds; while holding down
[PTT], the count down beeps sound.
After that, a long beep sounds.)
 s 1 beep sounds after the long beep when the Li-ion battery is selected.
 s 2 beeps sound after the long beep when the battery case is selected.
 s 3 beeps sound after the long beep when the Ni-MH battery is selected.
r After the beep sounds, release [PTT].
t Repeat steps w to r until you select the attached battery type.
./4% This operation may not be available, depending on the
presetting. Ask your dealer for details.
[VOL]
[VOL]
[PTT]
[ROTARY SELECTOR]