Icom IC-F3000 Series - DTMF Transmission and Remote Commands

D DTMF transmission
If the transceiver has [DTMF Autodial] assigned to it, the automatic
DTMF transmission function is usable.
± Push [DTMF Autodial] to transmit the DTMF code.
D 2ECEIVINGA3TUN+ILLAND2EVIVECOMMAND
The dispatcher can send a 2/5-tone signal that will stun, kill or re-
vive your transceiver.
When the Stun command is received, a beep sounds*, and the
transceiver becomes unusable. Receiving a Revive command is
necessary to operate the transceiver again in this case.
When the Kill command is received, a beep sounds*, and the trans-
ceiver becomes unusable (the transceiver switches to the cloning
required condition). Cloning the transceiver is necessary to operate
the transceiver again in this case.
* Depending on the presetting. Ask your dealer for details.
17
3
BASIC OPERATION