Icom IC-F3000 Series - Output Power and Priority Channel; MDC 1200 System Operation

N/UTPUTPOWERLEVELSELECTION
If the transceiver has [High/Low] assigned to it, the transmit output
power level can be selected, depending on the presetting.
When the battery case is selected as the battery type, or the bat-
tery voltage drops to a low power level and the LED indicator sta-
tus is “Low Battery 2,” the output power automatically switches to
“Low 1.” (pp. 7, 12)
± Push [High/Low] to select the transmit output power level.
 sBEEPSOUNDSWHENh,OWvISSELECTED
 sBEEPSSOUNDWHENh,OWvISSELECTED
 sBEEPSSOUNDWHENh(IGHvISSELECTED
N0RIORITY!CHANNELSELECTION
Depending on the presetting, the Priority A channel is selected
each time the transceiver power is turned ON.
N MDC 1200 system operation
The MDC 1200 signaling system enhances your transceiver’s capa-
bilities. It allows PTT ID* and Emergency signaling.
* When [PTT] is pushed and/or released, the transceiver transmits your
station ID.
D 4RANSMITTINGAN%MERGENCY#ALL
The MDC 1200 system’s Emergency feature can be accessed
using the [Emergency] key. The transceiver will send an Emergency
MDC 1200 system command once, or repeatedly for a programmed
number of times until it receives the acknowledgement signal.
The emergency call can be transmitted without a beep sound de-
pending on how the emergency function is programmed. Ask your
dealer for details.
20
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20