N Channel selection
Several types of channel selecting methods are available. They
may differ, according to your system set up.
To select a desired operating channel, do one of the following.
s2OTATE;2/4!293%,%#4/2=
s0USHONEOFMEMORYCHANNELKEYS;-2#(=TO;-2#(=
AUTOMATIC SCAN TYPE:
Selecting a channel is not necessary for this type. When turning the
power ON, the transceiver automatically starts scanning. Scanning
stops when a call is received.
./4% If the Move to Priority A channel at Power ON function
(p. 20) is turned ON, the transceiver does not start scanning at
power ON.
13
3
BASIC OPERATION
To Next Page
Loading...
Need help?
General
