N3ETTINGTHESQUELCHLEVEL
The squelch circuit mutes the received audio signal, depending on
the signal strength.
q Rotate [VOL] to turn the trans-
ceiver power OFF.
w3ET ;2/4!29 3%,%#4/2= TO
any channel other than Chan-
nel 16.
e While pushing and holding
[PTT] and [Lower], rotate [VOL]
to turn the power ON and enter
the squelch level adjustment
mode.
r Push [Upper] to increase the
squelch level (tight squelch), or
push [Lower] to decrease the
squelch level (loose squelch).
s4HEADJUSTABLERANGEISLOOSE
squelch) to 9 (tight squelch).
s!BEEPSOUNDSAFTERPUSHING;5PPER=OR;,OWER=
If the level is set on 0 or 9, an error beep sounds after pushing.
Therefore, you can determine the current level setting by the type
of beep that sounds.
t Rotate [VOL] to turn the power OFF, then ON to exit the squelch
level adjustment mode.
./4% This operation may not be available, depending on the
presetting. Ask your dealer for details.
19
3
BASIC OPERATION
To Next Page
Loading...
Need help?
General
