Icom IC-F3000 Series - Ni-MH Battery Charging Guidelines

24
4
"!44%29#(!2').'
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
If your Ni-MH battery pack seems to have no capacity, even after
being charged, completely discharge it by leaving the power ON
overnight. Then, fully charge the battery pack again. If the battery
pack still does not retain a charge (or only very little charge), a new
battery pack must be purchased. (p. 35)
Prior to using the transceiver for the first time, the battery pack
must be fully charged for optimum life and operation.
s2ECOMMENDEDTEMPERATURERANGEFORCHARGING
BETWEEN#AND#RAPIDCHARGEWITH"#OR
BETWEEN#AND#REGULARCHARGEWITH"#
s5SETHESUPPLIEDCHARGEROROPTIONALCHARGER"#FORRAPID
charging, BC-192 for regular charging) only. NEVER use other
manufacturers’ chargers.
The battery pack contains a rechargable battery.
Charge the battery pack before first operating the transceiver, or
when the battery pack becomes exhausted.
If you want to prolong the battery life, the following points should
BEOBSERVED
s!VOIDOVERCHARGING4HECHARGINGTIMEPERIODBYTHE"#
should be less than 48 hours.
s5SETHEBATTERYPACKUNTIL IT BECOMES ALMOST COMPLETELYEX-
hausted, under normal conditions. We recommend battery charg-
ing after transmitting becomes impossible.