Icom IC-F50V

1 - 1
SECTION 1 SPECIFICATIONS
M GENERAL
• Frequency coverage : TX/RX 136–174 MHz
• Number of conventional channels : 128 ch / 8 banks
• Type of emission : Wide 16K0F3E (25.0 kHz)
Middle 14K0F3E (20.0 kHz) [EUR] only
Narrow 11K0F3E (12.5 kHz)
• Antenna impedance : 50
Ω
(Nominal)
• Operating temperature range : –30˚C to +60˚C; –22˚F to +140˚F [USA], [EXP], [CHN]
–25˚C to +55˚C [EUR]
• Power supply requirement (nominal) : Specified Icom's battery packs only (7.2 V DC; negative ground)
• Current drain (Approx.) : Receiving 85 mA (stand-by)
500 mA (max. audio with internal speaker)
350 mA (max. audio with external speaker)
Transmitting 1.8 A (at 5.0 W)
0.7 A (at 1.0 W)
• Dimensions (Projections not included) : 56.0 (W)×97.0 (H)×36.4 (D) mm; 2
7
/32 (W)×3
13
⁄16 (H)×1
7
⁄16 (D) in.
• Weight (Incl. BP-227) : Approx. 280 g; 9
7
/8 oz.
M TRANSMITTER
• Output power : 5 W (High)/2 W (Low2)/1 W (Low1)
• Modulation : Variable reactance frequency modulation
• Maximum frequency deviation : ±5.0 kHz (Wide)
±4.0 kHz (Middle) [EUR] only
±2.5 kHz (Narrow)
• Frequency stability : ±2.5 ppm
• Spurious emissions : 70 dB typ. [USA], [EXP], [CHN]
0.25
μ
W (
≤
1 GHz), 1.0
μ
W (
>
1 GHz) [EUR]
• Adjacent channel power : 70 dB min. (Wide, Middle)
60 dB min. (Narrow)
• Audio harmonic distortion : 3% (at AF 1 kHz 40% deviation)
• FM Hum and noise (without CCITT filter)
[USA], [EXP], [CHN] only
: 40 dB min., 46 dB typ. (Wide)
34 dB min., 40 dB typ. (Narrow)
• Residual modulation (with CCITT filter)
[EUR] only
: 50 dB min., 55 dB typ. (Wide)
43 dB min., 53 dB typ. (Middle)
40 dB min., 50 dB typ. (Narrow)
• Limitting charact of modulator : 60–100% of max. deviation
• Microphone impedance : 2.2 k
Ω
M RECEIVER
• Receive system : Double-conversion superheterodyne system
• Intermediate frequencies : 1st IF: 46.35 MHz, 2nd IF: 450 kHz
• Sensitivity : 0.25
μ
V typ. at 12 dB SINAD [USA], [EXP], [CHN]
–4 dBµ V (EMF) typ. at 20 dB SINAD [EUR]
• Squelch sensitivity (at threshold) : 0.25
μ
V typ. [USA], [EXP], [CHN]
–4 dBµ V (EMF) typ. [EUR]
• Adjacent channel selectivity : 70 dB min., 75 dB typ. (Wide, Middle)
60 dB min., 65 dB typ. (Narrow)
• Spurious response : 70 dB
• Intermodulation rejection ratio : 70 dB min., 74 dB typ. [USA], [EXP], [CHN]
65 dB min., 67 dB typ. [EUR]
• Hum and noise (without CCITT filter)
[USA], [EXP], [CHN] only
: 40 dB min., 45 dB typ. (Wide)
34 dB min., 40 dB typ. (Narrow)
• Hum and noise (with CCITT filter)
[EUR] only
: 45 dB min., 55 dB typ. (Wide)
43 dB min., 53 dB typ. (Middle)
40 dB min., 50 dB typ. (Narrow)
• Audio output power
(at 5% distortion with an 8
Ω
load)
: 0.7 W typ. (max. audio with internal speaker)
0.5 W typ. (max. audio with external speaker)
• Audio output impedance : 8
Ω
Specifications are measured in accordance with TIA/EIA 603 ([USA], [EXP], [CHN]) or EN 300 086 ([EUR]).
All stated specifications are subject to change without notice or obligation.