Icom IC-F50V

13
3
BASIC OPERATION
■ Turning power ON
qRotate[VOL]toturnpowerON.
 •WhentheopeningvibrationfunctionisturnedON,thetransceiver
vibratesfor2sec.Askyourdealerfordetails.
w If the transceiver is programmed for a start up passcode, input
digit codes as directed by your dealer.
 •Thekeysinthetablebelowcanbeusedforpasswordinput:
 •Thetransceiverdetectsnumbersinthesameblockasidentical.
Therefore“01234”and“56789”arethesame.
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6
or
eWhenthe“PASSWORD”indicationdoesnotclearafterinput-
ting4digits,theinputcodenumbermaybeincorrect.Turnthe
power off and start over in this case.
■ Channel selection
Several types of channel selections are available. Methods may
differ according to your system set up.
NON-ZONE TYPE:
Push[CHUp]/[CHDown]toselectthedesiredoperatingchannel
insequence;or,pushoneof[MR-CH1]to[MR-CH4]toselecta
channel directly.
ZONE TYPE:
Push[Zone]thenpush[CHUp]/[CHDown]toselectthedesiredzone.
AUTOMATIC SCAN TYPE:
Channelsettingisnotnecessaryforthistype.Whenturningthe
power ON, the transceiver automatically starts scanning. Scanning
stops when receiving a call.