Icom IC-F50V - D Transmitting Notes

16
3
BASICOPERATION
3
D Receiving note
• Vibration function (Dependsontheversion)
WhenthematchedRXcodesignalisreceived,thetransceivermay
vibrateforaspeciedtimeperiod,dependingonthepre-setting.
Pushanykeyor[PTT]tostopthevibration.
NOTE:
•Thetransceivercannotstopthevibrationsuddenlyafterpush-
inganykeyor[PTT].
•Thevibrationsoundmaybeheardatthecommunicationparty,
orberecordediftherecordingfunctionisactivatedwhen[PTT]
is pushed to stop the vibration.
D Transmitting notes
• Transmit inhibit function
The transceiver has several inhibit functions which restrict trans-
mission under the following conditions:
-Thechannelisinmutecondition(‘Inaudible’condition;“
”
doesnotappear).
-Thechannelisbusy.
-Un-matched(ormatched)CTCSSisreceived.(Dependingon
thepre-setting)
-Theselectedchannelisa‘receiveonly’channel.
• Time-out timer
Aftercontinuoustransmissionforthepre-programmedtimeperiod,
thetime-outtimerstarts,causingthetransceivertostoptransmit-
ting.
• Penalty timer
Oncethetime-outtimerstarts,transmissionisfurtherinhibitedfor
a period determined by the penalty timer.