■Turning power ON
q Push [POWER] to turn the power ON.
• A power-up alert tone sounds for about 1 sec. and an opening
message may appear.
w If the transceiver is programmed for a start up passcode,
input digit codes as directed by your Dealer.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
KEY [P0] [P1] [P2] [P3] [P4]
NUMBER
0 1 2 3 4
5 6 7 8 9
e When the “PASSWORD” indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn power off and start over in this case.
■ Channel selection
Several types channel selections are available, methods
may differ according to your system set up.
NON-BANK TYPE:
Push [CH UP]/[CH DN] to select the desired operating
channel, in sequence; or, push one of the
[CH 1] to [CH 4] to
select a channel directly.
BANK-TYPE:
Push [BANK] to select the desired bank number.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
7
2
OPERATION
To Next Page
Loading...
