EasyManuals Logo

Icom IC-F7000 Service Manual Addendum

Icom IC-F7000
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
5 - 7
*The output level of the standard signal generator (SSG) is indicated as the SSG’s open circuit.
5-4 RECEIVER ADJUSTMENTS
”TOTAL GAIN”, “S-METER” and “DSC PEAK” adjustments must be performed at “ADJUSTMENT MODE”.
NOISE NULL
POINT
RECEIVER
GAIN
TOTAL GAIN
S-METER
1
1
1
1
2
• Operating frequency : 0.5 MHz
• Mode : A3E
Preset L209 parallel to top edge of its
chassis.
Preset L401, L403, L404, L405 and
L801 to max. counter clockwise.
Set the standard signal generator to
OFF (no signal output).
• Receiving
• Operating frequency : 13.9210 MHz
• Mode : J3E
Connect a standard signal generator
to the [ANT] connector and set as:
Frequency : 13.9210 MHz
Level : 0.5 µV*
(–113 dBm)
Modulation : OFF
• Receiving
While pushing HM-146’s [CALL]
switch and RC-26’s [EMG] switch,
then turn power ON.
Push [2] switch to enter the RX
adjustment mode.
Connect a standard signal generator
to the [ANT] connector and set as:
Frequency : 13.9210 MHz
Level : 320 µV*
(–57 dBm)
Modulation : OFF
• Receiving
Set the standard signal generator to
OFF (no signal output).
Set the standard signal generator as:
Frequency : 13.9210 MHz
Level : 10 mV*
(–27 dBm)
• Receiving
Front
panel
Front
panel
Connect an AC
millivoltmeter to the
[SP] jack with a 4
dummy load.
Connect an AC
millivoltmeter to the
[SP] jack with a 4
ohms dummy load.
Minimum output
level
Maximum
output level
MAIN
MAIN
R217,
R218
L207,
L208,
L210,
L211
ADJUSTMENT ADJUSTMENT CONDITIONS
UNIT LOCATION
VALUE
UNIT ADJUST
MEASUREMENT
ADJUSTMENT
Push the [OK] switch to write the adjustment value in the
memory.
Push the [OK] switch to write the adjustment value in the
memory.
Push the [OK] switch to write the adjustment value in the
memory.

Other manuals for Icom IC-F7000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-F7000 and is the answer not in the manual?

Icom IC-F7000 Specifications

General IconGeneral
BrandIcom
ModelIC-F7000
CategoryTransceiver
LanguageEnglish

Related product manuals