Icom IC-F8101 - Page 101

7V4.01– A-7264-2EX
Selcall setting D
Command: 1A 42
qw er
Call type
data
……
Call ID
or Link ID
Telephone number
Message, PIN code
Resevation
FFFF
XX XXXXXX XX XX
Call type data q
Call type
q Data
Telephone number/
Message/PIN code
Selective 00 —
Phone 01 Telephone number
Message 02 Message
Send Position 03 —
Get Position 04 —
Get Status 05 —
Emergency 21 —
Channel Test 24 —
Stun 28 PIN code
Call ID, Link ID w
If the ID is less than 6 digits, enter F into the rest
digits.
Example: Call ID is 123, enter 123FFF.
Telephone number, Message, PIN code r
• Telephone number: 1 to 16 digit(s)
ASCII code (30 to 39h
Number)
• Message: 1 to 64* characters
ASCII code (20 to 7Eh)
* Icom Selcall: Up to 64 characters
Open Selcall: Up to 32 characters
(After 33 characters are omitted.)
• PIN code*: 1 to 10 digit(s)
ASCII code (30 to 39h Number)
* Open Selcall only
Priority Network setting D
Command: 1A 50
X
q: Priority data
w: Network name
XXX
……
XX
00：OFF
01：ON
Network name w
ASCII 1 to 20 characters
Position data D
Command: 1A 60
…… ……
q: Latitude e: Longitude
w: Separator (0×2C)
XX XXXX XX XX
Latitude q
ASCII 11 Bytes.
Longitude e
ASCII 12 Bytes.
Model information D
Command: 1A A3
XX X XXX XXXXXX
……
e: Serial number (ESN)
t: Hardware version
q: Model name (ESN)
XXXX
……
w: Version (ESN)
XX XX XX
……
XX
……
XXXX
……
r: Hardware type
i: DSP version
y: Main CPU version
ESN: Electronic Serial Number
u: Front CPU version
Hardware type r
Hardware type
r Data
EXP 0 (ASCII)
AUS 1 (ASCII)
UN 2 (ASCII)
NoOP 3 (ASCII)
Data content description (Continued)