20
4
SELCALL/ALE OPERATION
2001 NEW 2001 NEW
Allows you to make Phone calls through a telephone
interconnect service provider.
• Preparation for a Phone call
Send a Channel Test call on several Phone call chan-
nels, and check the propagation on each one to select
the channel with the best signal quality. (p. 26)
• Sending a Phone call
q Hold down [ ] for 1 second to enter the Network
selection screen.
w Push [r] or [s] to select the desired Network, and
then push [ ].
• The Networks that belong to the Icom Selcall or Open
Selcall systems must be selected.
e Push [r] or [s] to select the Call Type to “Phone.”
• “Selective,” “Phone,” “Message,” “Send Position,” “Get Posi-
tion,” “Get Status,” “Emergency,” “Channel Test” and “Stun”
are selectab
le.
The Stun call is selectable in the Open Selcall.
r Push the keypad keys to enter the Number, and
then push [ ].
• The previously entered Number is displayed.
• Push [t](§) or [u](§§§) to move the cursor.
• Push [8] to delete the digit to the left of the cursor.
• This Number is not saved in the Number list.
t Push the keypad keys to enter the Phone Link ID,
and then push [ ].
• The previously entered Link ID is displayed.
• Push [t](§) or [u](§§§) to move the cursor.
• Push [8] to delete the digit to the left of the cursor.
• This ID is not saved in the Phone Link ID list.
y Push [r] or [s] to select the Profile, then push
[ ].
u Push [r] or [s] to select the channel.
• Only the channels that belong to the Network selected in
step w, are displayed.
• If desired, push [Tests](§§) to transmit the Channel Test
call in this step.
i Push [ ] to transmit the Phone call.
• While calling, push [ ] or [PTT] to cancel the call.
• The call is saved in the Call Out memory.
You can also make a Phone call when the Address
screen is displayed. In this case, you can skip sev-
eral steps, see page 29 for the Simple Selcall opera-
tion details.
• After a Phone call
q When a Phone call is finished, push [ ] to trans-
mit the disconnect call.
• Until the Disconnect call is transmitted, the telephone
interconnect service provider continues counting the
time for toll charging.
• If the “Auto Start Type” item of “Setmode” is set to “Scan”
or “Termination,” the Call automatically disconnects after
the Auto Start Wait Time period has past with no opera-
tion.
(Setmode > Call)
D Phone call
To Next Page
Loading...
Need help?
General
