5V4.01– A-7264-2EX
Command table (Continued)
Cmd.
Sub
cmd.
Set mode
Data Description
Category
Item
1A 37 0000
to
0002
Send/read the TX status
( 0000=RX, 0001=TX by PTT,
0002=TX by ACC PTT)
• If you want to change the TX
status between the PTT and ACC
PTT, rst change to the RX status,
then select the TX status.
38 Send/read the memory channel
(ASCII 1 to 20 characters)
40 Send the Hangup command
While calling: Stop calling
While linking the Selcall Phone Link
or ALE link, sends the disconnect
call.
41 See
p. 6
Send the ALE Call output setting
42 See
p. 7
Send the Selcall output setting
50 00/01 Send/read the Priority Network
setting
60 See
p. 7
Read the GPS position
A3 See
p. 7
Read the Model information
1C 00 00/01 Send/read the PTT output setting
(00=RX, 01=PTT TX)
01 00 to
02
Send the Antenna tuner operation
( 00=Through, 01=Tuner ON,
02=Manual tune)
Read the Antenna Tuner status
(00=Tuner ON, 01=Through)
To Next Page
Loading...
Need help?
General
