Need help?Do you have a question about the Icom IC-G86 and is the answer not in the manual?
General| Frequency Range | 136-174 MHz |
|---|---|
| Frequency range, TX/RX | 136-174 MHz |
| Mode | FM |
| Channels | 200 |
| Dimensions | 120 x 54 x 34 mm |
| Waterproof Rating | IP54 |
| Receiver System | Double-conversion superheterodyne |
| Waterproof Standard | IP54 |
| Type | Handheld |
| Power Output | 5W / 1W |
| RF Power output | 5W (High), 1W (Low) |
| Battery | Li-ion, 7.4V, 2000mAh |
| Battery Life | 10 hours (approx.) |
Crucial warnings and instructions for safe transceiver use.
Explains the meaning of warning, caution, and note indicators.
Highlights the key capabilities and design aspects of the transceiver.
Lists items included with the transceiver.
Instructions for attaching and securing the antenna.
Procedures for attaching and detaching the belt clip.
Steps for attaching and detaching the battery pack.
Instructions for attaching and detaching the jack cover.
Overview of available battery chargers and their functions.
Procedure for rapid charging BP-264 with BC-191.
Procedure for regular charging BP-264 with BC-192.
Procedure for rapid charging BP-298/BP-299 with BC-240.
How to adjust the audio output level of the transceiver.
How to set transmission and reception passband width.
Assigning the VOL knob function for channel selection or volume control.
Understanding repeater use for communication in an area.
Using the transceiver-to-transceiver communication mode.
Superimposing DTCS codes on transmitted signals.
Preventing interference by inhibiting transmission.
Setting subaudible tones for repeater access.
Overview of automatic signal searching methods.
Scanning through programmed memory channels.
Monitoring a selected channel while scanning others.
Configuring channels to be skipped during memory scanning.
Defining how the scan pauses and resumes.
Using tones or codes to open squelch for specific signals.
Notifying reception of calls using subaudible tones.
Detecting necessary tone frequencies or DTCS codes.
Entering and storing DTMF codes in memory.
Methods for sending DTMF code sequences.
Listening to programmed DTMF code sequences.
Adjusting the speed of DTMF code transmission.
How to access and navigate the Set mode for configuration.
Description of configurable settings within the Set mode.
Accessing and using the Initial Set mode for seldom-changed settings.
Description of seldom-changed settings available in Initial Set mode.
Overview of transferring programmed data.
Transferring data between two units using a cable.
Transferring data between transceiver and PC via software.
Common issues and solutions for transceiver operation.
List of available optional accessories and their functions.
Installation and usage of the BP-263 battery case.
Using the voice-operated transmission feature.
To Next Page
