Icom IC-G86 - LCD Contrast; Simple Mode; Dial Assignment; DTMF Speed

8
SET MODES
8-6
DTMF speed
Set the rate at which DTMF memories send individual
DTMF characters to accommodate your operating
needs. (Default: dtd. 1)
• dtd. 1: 100 milliseconds interval: 5.0 cps rate
• dtd. 2: 200 milliseconds interval: 2.5 cps rate
• dtd. 3: 300 milliseconds interval: 1.6 cps rate
• dtd. 5: 500 milliseconds interval: 1.0 cps rate
(cps=characters per second)
Dial assignment
Selects whether or not to use [VOL] as a channel
selector, instead of [Y] and [Z]. When [VOL] functions
as a channel selector, [Y] and [Z] function as volume
controls.
(Default: tOP.VO)
Option [VOL] [Y]/[Z]
tOP.VO Volume control Channel selectors
tOP.di Channel selector Volume controls
Simple mode
Selects whether or not to inhibit the access to some
functions in the Set mode. (Default: SmP.OF)
• SmP.OF: All settings can be accessed.
• SmP.On:
Some functions cannot be accessed.
NOTE: When “SmP.On” is selected, only the
following functions can be accessed in the Set mode.
• Scan resume setting
• Function key timer
• LCD backlight
• VOX gain
• MIC gain
• VOX delay
• VOX time-out timer
• DTMF TX key
LCD contrast
Selects the LCD contrast. (Default: Lcd.At)
• Lcd.LO: Sets the contrast to low.
• Lcd.At:
Sets the contrast to high.
However, if the transceiver is exposed to
high temperatures, it automatically sets
the contrast to low.
Power save
The Power Save function enables you to conserve
battery life by selecting the duty cycle of the receiver.
Select the ratio of the power save time to the standby
time. To turn OFF the function, select “P–S.OF.”
(Default: P–S.At)
• P–S.OF: Turns OFF the function.
• P–S. 2: Sets the duty cycle to 1:2.
(ON: 0.1 second, OFF: 0.2 seconds)
• P–S. 8: Sets the duty cycle to 1:8.
(ON: 0.1 second, OFF: 0.8 seconds)
• P–S.16: Sets the duty cycle to 1:16.
(ON: 0.1 second, OFF: 1.6 seconds)
• P–S.At: Automatically sets the duty cycle.
When no operation occurs and no signal
is received for 5 seconds, the transceiver
enters the Power Save mode, and sets
“1:2” as the duty cycle, and after 60
seconds, it sets “1:16” as the duty cycle.
Select speed
Selects whether or not to accelerate the turning speed
when rotating [VOL] rapidly. (Default: S–S. At)
• S–S. m: Turns OFF the tuning speed acceleration.
• S–S. At: The turning speed is automatically
accelerated when rapidly rotating [VOL].
Initial Set mode items