Icom IC-G86 - Subaudible tones

4
REPEATER OPERATION
4-4
Subaudible tones
Some repeaters require subaudible tones to access.
Subaudible tones are superimposed over your normal
signal, and must be set in advance.
1. Push [FUNC], and then push [SET] to enter the
Set mode.
2. Push [Y] or [Z ] to select the repeater tone item.(rt)
3. Rotate [VOL] to select the desired subaudible
tone frequency.
4. Push [#ENT] to exit the Set mode.
D Tone information
Some repeaters require a different tone system to be
accessed.
DTMF Tones
While holding down [PTT], push the desired DTMF
keys, [0] to [9], [MONI](A), [Y](B), [Z](C), [ ](D),
[*](E), and [#ENT](F) to transmit their assigned DTMF
codes.
DTCS codes
Push [FUNC](*), and then [TONE](1) one or more times
to activate the DTCS encoder, and then push [PTT].
• “
D
” and “ ” is displayed.
• The specied DTCS code is superimposed over
your transmitted signal.
L See the CTCSS tone or DTCS code. (p. 6-2)
NOTE: If you don’t know the subaudible tone or
DTCS code used for a repeater, the tone scan is
convenient for detecting it.
Push [FUNC](*), and then [T.SCAN](3) to start a tone
scan.
• When the required tone frequency or DTCS code is
detected, the scan pauses, and it is temporarily set.
L See the Tone scan function. (p. 6-5)
Available subaudible tones
67.0 79.7 94.8 110.9 131.8 156.7 171.3 186.2 203.5 229.1
69.3 82.5 97.4 114.8 136.5 159.8 173.8 189.9 206.5 233.6
71.9 85.4 100.0 118.8 141.3 162.2 177.3 192.8 210.7 241.8
74.4 88.5 103.5 123.0 146.2 165.5 179.9 196.6 218.1 250.3
77.0 91.5 107.2 127.3 151.4 167.9 183.5 199.5 225.7 254.1
Setting the subaudible tone
[DIAL]
88.5 Hz repeater tone