Icom IC-G86 - Accessories; Supplied accessories; Antenna; Belt clip

To Next Page

To Previous Page

1-1

Section 1

ACCESSORIES

Supplied accessories..............................................................................1-2

Antenna ..................................................................................................1-2

Belt clip ...................................................................................................1-2

Battery pack or case ...............................................................................1-3

Jack cover ..............................................................................................1-3

Main Page

Table of Contents1
Features2
Introduction2
Explicit Definitions2
Accessories3
Supplied Accessories4
Belt Clip4
Antenna4
Battery Pack5
Jack Cover5
Battery Charge6
Advanced Operation9
Adjusting the Audio Level10
Selecting Passband Width10
VOL Function Assignment10
Repeater Operation11
About Repeater12
Talk Around Function12
Turning on the Subaudible Tone Encoder12
Turning on the Talk Around Function12
DTCS Encoder13
Lockout Function13
Available Subaudible Tones14
Subaudible Tones14
Setting the Subaudible Tone14
Tone Information14
Scan Operation15
Scan Types16
Memory Scan16
Priority Watch16
Setting Skip Channels17
Scan Resume Setting17
Tone Squelch and Pocket Beep18
Recommended CTCSS Tones19
Setting CTCSS Tone or DTCS Code19
Setting DTCS Polarity19
Tone/Dtcs Squelch19
Operation20
Pocket Beep Function21
Tone Scan22
DTMF Memory23
Programming a DTMF Code Sequence24
DTMF Code Assignment24
Programming Mode Indication24
DTMF Code Transmission Interlocking with PTT25
Using a DTMF Memory Channel25
Manual DTMF Code Transmission25
Transmitting a DTMF Code25
Monitoring a DTMF Memory26
Setting DTMF Transfer Speed26
Table of Contents27
Set Modes27
Repeater Tone Frequency28
Tone Squelch Frequency28
Section 8 SET MODES28
Using the Set Mode28
Set Mode Items28
- MIC Gain29
- Function Key Timer29
- VOX Gain29
- LCD Backlight29
- DTMF TX Key30
- Mode30
- Extra High Power31
- Time-Out Timer31
Using the Initial Set Mode31
Initial Set Mode Items31
- LCD Contrast32
- Simple Mode32
- Dial Assignment32
- DTMF Speed32
- Microphone Simple Mode33
- Voltage Indication33
- Battery Protection Function33
- Auto Low Power33
- Programming34
- Programming Operation35
- Programming between Two Transceivers35
- Programming Using a PC35
- During Programming Mode35
- Troubleshooting36
- Options38
- Battery Packs/Battery Case39
- Chargers39
- DC Cables39
- Others39
- Optional Battery Case40
- VOX Function41
- Optional Unit Connection41
- Turning the VOX Function on or off41
- VOX-Related Settings42
- VOX Delay42
- VOX Time-Out Timer42

Icom IC-G86 - Accessories; Supplied accessories; Antenna; Belt clip

Table of Contents

Related product manuals