3
BASIC OPERATION
9
■ Call channel programming
The call channel is used to select Channel 9, however, you
can program your most often-used channels in each channel
group for quick recall.
q While pushing [H/L], push [CH] one or more times to se-
lect the desired channel group (International or U.S.A.) to
be programmed. (U.S.A. channel group is available for UK
and Italy versions only.)
w Push [16] for 1 sec. to select the call channel of the se-
lected channel group.
•“CALL” and call channel number appear.
e Push [16] again for 3 sec. (until
long beep changes to 2 short
beeps) to enter call channel pro-
gramming condition.
•Channel number starts flashing.
r Push [Y]/[Z] to select the de-
sired channel.
t Push [16] to program the dis-
played channel as the call chan-
nel.
• Push [CH] to cancel.
•The channel number stops flashing.
■ Memory channel names
Memory channels can be tagged with alphanumeric names
of up to 10 characters each.
Capital letters, small letters, numerals, some symbols (! " # $
% & ' ( ) ✱ +
,
–
.
⁄ ) and spaces can be used.
q Select the desired memory channel.
• Cancel dual watch, tri-watch or scan in advance.
w While pushing [H/L], push [16] to edit memory channel
name.
• A cursor appears and blinks.
e Select the desired character by pushing [Y]/[Z].
• Push [CH] or [H/L] for cursor movement.
r Push [16] to input and set the name.
• Push [H/L] to cancel.
•The cursor disappears.
t Repeat steps q to r to program other memory channel
names, if desired.
To Next Page
Loading...
