10
4
DUALWATCH/TRI-WATCH
■ Description
Dualwatch monitors Channel 16 while you are receiving an-
other channel; tri-watch monitors Channel 16 and the call
channel while receiving another channel.
DUALWATCH/TRI-WATCH SIMULATION
•If a signal is received on Channel 16, dualwatch/tri-watch pauses
on Channel 16 until the signal disappears.
•If a signal is received on the call channel during tri-watch, tri-watch
becomes dualwatch until the signal disappears.
•To transmit on the selected channel during dualwatch/tri-watch, push
and hold [PTT].
■ Operation
q Select the desired operating channel.
w Select dualwatch or tri-watch in set mode. (p. 15)
e Push [CH] for 1 sec. to start dualwatch or tri-watch.
•“ ” appears during dualwatch; “” appears during tri-watch.
• Beep tone sounds when a signal is received on Channel 16.
r To cancel dualwatch/tri-watch, push [CH] again.
To Next Page
Loading...
