Icom IC-M401EURO - Set Mode; I Set Mode Programming

6
SET MODE
14
■ Set mode programming
Set mode is used to change the conditions of some of the
transceiver’s functions.
NOTE: Available functions may differ depending on dealer
setting.
Entering set mode
q Turn power OFF.
w While pushing [16], turn power ON to enter set mode.
e After the display appears, release [16].
r Push [16] to select the desired item, if necessary.
t Push [Y]/[Z] to select the desired condition of the item.
y Turn power OFF, then ON again to exit set mode.
Scan mode Scan resume timer Dual/tri watch
LCD contrast
Beep tone
Push
• SET MODE CONSTRUCTION
0 IC-M401EURO_ (2).qxd 01.12.10 11:16 AM Page 14 (1,1)