Icom IC-M423GE - Page 40

When receiving a Distress Relay Call, you can transmit an
ac knowledgement, as shown below.
q When a Distress Relay Call is received, alarm sounds and
the screen shown below is displayed.
Push [ALARM OFF] to stop the alarm.
• Even if you do not push [ALARM OFF], the alarm stops after 2
minutes, and then the screen in step w is displayed.
w Push [ACPT].
• Even if you do not push [ACPT], the screen in step e is dis-
played after 10 seconds.
• Push [IGN] to ignore the call and return to the normal operating
mode.
• Push [INFO] to display the Distress Relay Call information.
• Push [PAUSE] to pause the countdown.
About Received call information:
• Push [IGN] to ignore the call and return to the normal operating
mode.
• Push [BACK] to return to the previous screen.
• Push [ACPT] to go to the next step.
e Push [ACK].
• Push [EXIT] to return to the normal operating mode.*
*The exit confirmation dialog is displayed.
30
7
DSC OPERATION
D Making a Distress Relay Acknowledgement
(For only USA version transceivers)