37
7
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
e Select a desired intership channel using Dial or [Y]/[Z],
then push [ENT].
• Intership channels are already preset into the transceiver in the
recommended order.
About Manual Entry:
Enter a desired group ID in the following way:
• Select a desired number using Dial, or [Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, “←” or “→,” then push
[ENT] or Dial.
• The first digit is specified as ‘0,’ and the second digit is other than
‘0’ for a Group ID.
• The first two digits are ‘0’ for any Coast station ID.
r A confirmation screen is displayed.
• Confirm the call contents.
t Push [CALL] to make a Group call.
• If Channel 70 is busy, the transceiver stands by until the channel
becomes clear.
y After the Group call has been transmitted, the following
screen is displayed.
u Announce the information using the microphone.
i After the announcement, push [EXIT] to return to the nor-
mal operating mode.*
* Only USA version, the exit confirmation dialog (p. 29) is displayed.
• Only USA version, push [RESEND] to resend the call.
Displayed
for only USA
version.
To Next Page
Loading...
