Icom IC-R5 - Automatic Adjustments

5 - 8
5-4 AUTOMATICALLY ADJUSTMENTS
• The following adjustments must be performed at “ADJUSTMENT MODE”.
• The following adjustments can be ajusted automatically.
• In case of be finished to adjust “BAR ANTENNA”, “VHF SENSITIVITY” and “UHF SENSITIVITY” ADJUSTMENTS already,
DO NOT need to perform the following adjustment.
BAR
ANTENNA
VHF
SENSITIVITY
UHF
SENSITIVITY
ADJUSTMENT ADJUSTMENT CONDITION OPERATION
1
2
1
2
1
2
• Displayed frequency : (trL ch) 0.495 MHz
• Connect the SSG to the antenna connector and set as :
Level : 40 mV
* (–15 dBm)
Modulation : OFF
• Receiving
• Displayed frequency : (trH ch) 1.620 MHz
• Set the SSG level : 50 mV
* (–13 dBm)
• Receiving
• Displayed frequency : (trL ch) 118.100 MHz
• Set the SSG level : 1.0 µV
* (–107 dBm)
• Receiving
• Displayed frequency : (trH ch) 174.900 MHz
• Receiving
• Displayed frequency : (trL ch) 330.100 MHz
• Set the SSG level : 1.0 µV
* (–107 dBm)
• Receiving
• Displayed frequency : (trH ch) 469.900 MHz
• Receiving
*This output level of the standard signal generator (SSG) is indicated as SSG’s open circuit.
Push the [V/M] key.
Push the [V/M] key.
Push the [V/M] key.
Push the [V/M] key.
Push the [V/M] key.
Push the [V/M] key.