■ Operations while the IC-R8600 is in the I/Q mode
You need to enter the I/Q mode to get I/Q signals.
While the IC-R8600 is in the I/Q mode, [REMOTE] LED lights and the IC-R8600 is in the “Remote controlled
mode,” thus you cannot operate the IC-R8600.
To exit the I/Q mode, send the command that cancels the mode, or push the [LOCAL] key on the IC-R8600
front panel. Turning OFF the IC-R8600’s power also exits the I/Q mode.
While the IC-R8600 is in the I/Q mode, the operations that a user can perform are limited.
D Operation limitations in the I/Q mode
Setting:
All changes (frequency, preamp setting, and so on) made in the I/Q mode are not saved.
All the settings will be returned to the condition/state before entering the I/Q mode.
Receive setting:
While in the I/Q mode, the receive mode is xed to “USB,” and “AGC” is forcibly turned OFF.
Audio output:
Audio output from the internal speaker, external speaker terminal and headphone terminal are muted.
The audio output from the USB Audio, [AF/IF] terminal and [LAN] port are not muted.
The Monitor function is forcibly turned OFF.
Others:
• Normal scan, Priority scan and Tone scan are not usable. (Forcibly canceled if running.)
• The Recording function is not usable.
• The Memory channel is not automatically changed by the Timer function.
(The Automatic Power OFF function is still usable.)
• The BER measurement function is not usable, and forcibly turned OFF if in use.
• “NG (FA)” will be returned to all the commands excepts those related to the I/Q mode: reading and entering
the I/Q mode. Setting receive frequency, receive mode transceive and receiving digital signals are disabled.
• The cloning operation using the CS-R8600 is not usable.
• The IF signal from the 10.7 MHz OUT is disabled.
I/Q SIGNAL
13
To Next Page
Loading...
