EasyManuals Logo

Icom IC-T70A Service Manual

Icom IC-T70A
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
This service manual describes the latest technical
information for the IC-T70A
and
IC-T70E VHF/UHF DUAL
BAND FM TRANSCEIVER, at the time of publication.
NEVER connect the transceiver to an AC outlet or to a DC
power supply that uses more than the specified voltage.
This will ruin the transceiver.
DO NOT expose the transceiver to rain, snow or any liquids.
DO NOT reverse the polarities of the power supply when
connecting the transceiver.
DO NOT apply an RF signal of more than 20 dBm (100 mW) to
the antenna connector. This could damage the transceiver’s
front-end.
To upgrade quality, any electrical or mechanical parts
and internal circuits are subject to change without notice
or obligation.
MODEL VERSION
SUPPLIED
BATTERY PACK
SUPPLIED
CHARGER
IC-T70A
TPE
BP-264
BC-167SA
USA
KOR
AUS BC-167SV
EXP BC-167SA
EXP-01 BC-167SD
IC-T70E
EUR BC-167SD
UK
CHN
RSP BP-264 BC-167SD
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit Icom part number
2. Component name
3. Equipment model name and unit name
4. Quantity required
<ORDER EXAMPLE>
1110007320
NJM2591V
IC-T70A MAIN UNIT 2 pieces
8310075430 3253 WINDOW PLATE
IC-T70E CHASSIS 10 pieces
Addresses are provided on the inside back cover for your
convenience.
ORDERING PARTS
1. Make sure that the problem is internal before
disassembling the transceiver.
2. DO NOT open the transceiver until the transceiver is
disconnected from its power source.
3. DO NOT force any of the variable components. Turn
them slowly and smoothly.
4. DO NOT short any circuits or electronic parts. An
insulated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the
transceiver is defective.
6. DO NOT transmit power into a Standard Signal
Generator or a Sweep Generator.
7. ALWAYS connect a 50 dB to 60 dB attenuator between
the transceiver and a Deviation Meter or Spectrum
Analyzer, when using such test equipment.
8. READ the instructions of the test equipment throughly
before connecting it to the transceiver.
REPAIR NOTES
INTRODUCTION
CAUTION
(IC-T70A)
UNIT ABBREVIATIONS:
AC: ACCESSORY
CH: CHASSIS
M: MAIN UNIT
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia and/or other countries.
All manuals and user guides at all-guides.com

Other manuals for Icom IC-T70A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-T70A and is the answer not in the manual?

Icom IC-T70A Specifications

General IconGeneral
Operating frequency144 – 148, 440 – 450 MHz
Display typeLCD
Backlight displayYes
Antenna connector typeFA-S270C
Number of antenna connectors1
Battery typeBP-265
Product colorBlack
Operating temperature (T-T)-20 - 60 °C
Number of batteries included1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth30 mm
Width58 mm
Height111 mm
Weight380 g

Related product manuals