Icom ID-880H

3 - 1
1. REMOVING TOP AND BOTTOM COVERS
1) Unscrew total of 18 screws; 4 screws from the top cover,
8 screws from the both sides and 4 screws from the
bottom cover.
2) Remove the top cover and bottom cover as illustrated
below.
SECTION 3. DISASSEMBLY INSTRUCTION
(Continued to right above.)
2. REMOVING THE MAIN UNIT
1) Remove the IC clip from the chassis.
2) Disconnect the speaker cable from the MAIN UNIT, and
remove the speaker from the chassis.
Top cover
Bottom cover
IC clip
SPEAKER
CABLE
<Top view>
Speaker
Screw x4
Screw x10
COOLING
FAN CABLE
UNSOLDER
Solder
remover
<Bottom view>
MAIN UNIT
Front panel
LCD plate
CONTROL UNIT
Rear panel
Screw x4
Knobs
Front panel
2. REMOVING THE MAIN UNIT (continued)
3) Unscrew 10 screws from the MAIN UNIT.
4) Unscrew 4 screws from the chassis.
5) Disconnect the cooling fan cable from the MAIN UNIT.
6) Unsolder total of 4 points, and take off the MAIN UNIT.
3. DISASSEMBLE THE CONTROL UNIT
1) Remove 3 knobs from the front panel.
2) Unscrew 4 screws from the rear panel.
3) Remove the LCD plate.
4) Take off the CONTROL UNIT from the front panel.