Icom MA-510TR - Vessel Information Setup; Entering Own Ship Data

5
3
PREPARATION
■ Entering Own ship data
Your vessel’s information is exchanged among vessels and/or base stations.
NOTE: After entering the MMSI code, the transponder automatically enters the “OWN
SHIP DATA” screen. In this case, skip steps 1 ~ 3.
1. Push [MENU].
• The Menu screen is displayed.
2. Push [▲] or [▼] to select “AIS settings,” and then
push [ENT].
• The “AIS SETTINGS” screen is displayed.
L Holding down [▲] or [▼] sequentially scrolls up or
down through the Menu screen.
3. Push [▲] or [▼] to select “Own ship data,” and then
push [ENT].
• The “OWN SHIP DATA” screen is displayed.
4. Push [▲] or [▼] to select an item.
L See the next page for details.
5. Push [▲] or [▼] to select or enter an option or value,
and then push [ENT].
• The transponder returns to the previous screen.
TIP:
• Select a number, character, or space using [▲],
[▼], [◄], and [►].
• Push [ENT] to enter the selected number or
character.
• Select “←” or “→” on the screen to move the cursor.
6. Repeat steps 4 and 5 to set other items.
7. When the transponder automatically enters the “OWN
SHIP DATA” screen after entering the MMSI code,
push [CLR] to finish entering Own ship data.
• “Your information entry nished.” is displayed.