Icom MA-510TR - AIS List Management; Using the AIS List Screen

16
5
BASIC OPERATION
5
7
10
15
18
8
13
11
16
9
14
6
12
17
1
4
2
3
■ Using the AIS list screen
There are 3 types of AIS lists, Target, Danger, and Friends.
The target’s information is automatically updated every 5 seconds, and then the AIS
target data is sorted.
1. Push [MENU].
• The Menu screen is displayed.
2. Push [▲] or [▼] to select “AIS list,” and then push
[ENT].
• The “AIS LIST” screen is displayed.
3. Push [▲] or [▼] to select a list, and then push [ENT].
• The list screen is displayed.
4. Push [▲] or [▼] to select an AIS target.
5. Push [ENT] to display the Menu window.
• The Menu window is displayed.
6. Select “Details,” and then push [ENT] to display the
detail screen. (p. 19)
• The “DETAILS” screen is displayed.
NOTE: An alarm sounds when a malfunction occurs, an
AIS target is closer than the CPA and TCPA settings, and
so on, depending on the presetting. To stop the alarm
buzzer, push any key.
L If the popup screen is displayed, push any key again to
turn it OFF.
TIP: The selected target in the list can be displayed on
the plotter display.
1. Repeat steps 1 ~ 5.
2. Select "Display on plotter," and then push [ENT].
• The plotter display is displayed, and a target box is
displayed around the selected target. (p. 13)
• When the selected target is out of range, a popup
screen is displayed.