44
8
CONNECTIONS AND INSTALLATION
8
10
15
18
13
11
16
9
14
12
17
1
7
4
2
5
3
6
■ MB-132 installation
An optional MB-132
such as an instrument panel.
CAUTION: Keep the transponder at least 1 meter (3.3 feet) away from your vessel’s
magnetic navigation compass.
1. Using the template on page 50, carefully cut a
hole in the instrument panel, or wherever you plan to
mount the transponder.
2. Slide the transponder through the hole, as shown to
the right.
3. Attach the clamps on both sides of the transponder
using 2 supplied (M5 × 8 mm) bolts.
L Make sure that the clamps align parallel to the
transponder’s body.
4. Tighten the end bolts on the clamps (rotate clockwise)
so that the clamps press firmly against the inside of
the instrument control panel. (Torque: 0.6 N•m)
5. Tighten the locking nuts (rotate counterclockwise) so
that the transponder is securely mounted in position,
as shown to the right.
6. Connect the antenna and power cables, then return
the instrument control panel to its original place.
To Next Page
Loading...
