Icom MA-510TR - Transceiver Integration; Connecting to the Transceiver; Fuse Replacement Procedure

42
8
CONNECTIONS AND INSTALLATION
8
1
7
4
2
5
3
6
10
15
18
13
11
16
9
14
12
17
■ Fuse replacement
One fuse is installed in the supplied DC power cable. If the fuse blows or the transponder
stops functioning, track down the source of the problem, repair it, and replace the
damaged fuse with a new one of the proper rating.
Fuse rating: 3 A
■ Connecting to the transceiver
Connect the transponder and a transceiver using the accessory cable. After connecting,
an Individual DSC call can be made to the AIS target using the transponder without
entering the target’s MMSI code. (p. 31)
Connect each lead to the appropriate lead as follows.
See the instruction manual of each for transceiver’s connecting instructions.
L The following transceivers can operate with this function. (As of November 2019)
IC-M605/IC-M605EURO/IC-M506/IC-M506GE/IC-M424G/IC-M400BB/
IC-M330/IC-M330GE/IC-M330G/IC-M220
D IC-M605/IC-M605EURO
• NMEA 1 OUT (+) or NMEA 2 OUT(+): To NMEA IN (+).
• NMEA 1 OUT (–) or NMEA 2 OUT(–): To NMEA IN (–).
• NMEA 1 IN (+) or NMEA 2 IN (+): To NMEA OUT (+).
• NMEA 1 IN (–) or NMEA 2 IN (–): To NMEA OUT (–).
IC-M605/IC-M605EURO’s rear panel view
NMEA 1 IN (+)
NMEA 1 IN (–)
NMEA 1 OUT (+)
NMEA 1 OUT (–)
NMEA 2 OUT (+)
NMEA 2 OUT (–)
NMEA 2 IN (–)
NMEA 2 IN (+)
D IC-M506/IC-M506GE/IC-M424G/IC-M400BB/
IC-M330/IC-M330GE/IC-M330G/IC-M220
• Listener A (Data-H) (Yellow): To NMEA OUT (+).
• Listener B (Data-L) (Green): To NMEA OUT (–).
• Talker A (Data-H) (White): To NMEA IN (+).
• Talker B (Data-L) (Brown): To NMEA IN (–).
NOTE:
• When an external GPS receiver is not connected, RMC, GSA, and GSV sentences
are only output from the internal receiver.
• When the NMEA sentences are input from an external GPS receiver, all the
sentences*, as described to the left, are passed to the output terminal.
*The external GPS receiver requires the GBS sentence output.