Icom MR-1000TIII - SPD Adjustment; Range Selection

34
11
SERVICE MAN MENU
■ SPD adjustment
qPush [MENU]/[ ], [Ú] and [
≈
] several times to
display the “SERVICE MAN” menu.
wPush [Ú] until the “SPD ADJ.” section becomes
highlighted.
ePush [
Ω≈
] to enter the pulse rate (pulse numbers
per one nautical mile) of the speed sensor unit.
rPush [MENU]/[ ] to return to the normal screen.
■ RANGE selection
qPush [MENU]/[ ], [Ú] and [
≈
] to display the
“SERVICE MAN” menu.
wPush [Ú] until the “RANGE” section becomes high-
lighted.
ePush [Ù Ú] to choose the selectable screen ranges
with [+]/[ ] or [–]/[ ] on the display.
rPush [
Ω
] to skip from the range selection, or push
[
≈
] to cancel skipping.
tPush [MENU]/[ ] to return to the normal screen.
Selectable ranges:
1
⁄8
,
1
⁄4
,
1
⁄2
,
3
⁄4
, 1, 1.5, 2, 3, 4, 6, 8,
12, 16, 24, 32, 36, 48*, 64
†
, 72
†
(NM)
*48 NM range is available for the MR-1000TII/TIII.
†
64 and 72 NM ranges are available for the MR-1000TIII only.
SERVICE MAN
SPD ADJ.
HDG ADJ. 0.0
˚
HV
SETUP MEMORY
24000 MONITOR
HEATER
5731.0H
TX TIME
30.0
OUTPUT
ENGLISH
VOLTAGE
MG
340
75
3.0
0.55
TIMING ADJ.
1/8 3/4 2 6
1/4 1 3 8
1/2 1.5 4 12
16
24
32
36
48
RANGE
*
1
⁄4 NM range will be skipped.
72
64