Icom MR-1000TIII - External Data List

The following external bearing, speed, position and way point data is (are) required , when you use the radar func-
tions.
*
1
OG; Over ground, TW; Through the water
*
2
NMEA1 and NMEA2 connectors; See p. 24
•“HDT”, “HDM”, “RMC”, “GGA”, “GLL”, “VTG”, “WPL”, “GNS” and “BWC” are SENTENCES of the NMEA0183.
•If BRG INPUT is set to “GPS”, “RMC” of NMEA2 connector or COG (Course Over the Ground) of “VTG” a bow it
receives as a direction, even if there is no direction information (compass etc.) in NMEA1 connector, the screen
display of the North rise etc. is possible.
However, direction accuracy falls when the speed of a ship is set to 2 or less kts, or when exceeding 3 kts a bow
it does not receive as direction data. Moreo, the influence of measurement position accuracy or a current an actual
bow it may differ from a direction.
15
39
EXTERNAL DATA LIST
EXTERNAL DATA INPUT
NMEA1*
2
NMEA2*
2
“HDT”, “HDM”“RMC”, “GGA”, “GLL”, “VTG”, “WPL”, “BWC”, LOG, “GNS”
N+1, AUX
FUNCTION DISPLAY BEARING SPEED POSITION WAY POINT
HEAD UP HU
COURSE UP CU Required
NORTH UP NU Required
TRUE MOTION OG*
1
TM Required “RMC”, “GGA” or “GLL”, “GNS”
TW*
1
TM Required LOG
SPEED DISPLAY OG*
1
SOG “RMC” or “VTG”
TW*
1
STW LOG
HEADING BEARING HDG Required
WAY POINT WPT Required “RMC”, “GGA” or “GLL”, “GNS”“WPL” or “BWC”
OWN VECTOR OG*
1
Required “RMC” or “VTG”
TW*
1
Required LOG
MOB MOB Required “RMC”, “GGA” or “GLL, “GNS”
ATA OG*
1
ATA Required “RMC” or “VTG”
TW*
1
ATA Required LOG
VRM/PI/WPT/MOB estimated OG*
1
“RMC” or “VTG”
time of arrival TW*
1
LOG
MAGNETIC VARIATION (AUTO) “RMC” or “VTG”