54
Punch:
Punch is recording which overwrites existing audio or MIDI within a set punch area.Tap Punch to
XYZXYZXYZXYZXYZXYZ. This is a key workow tool because of the time saved by combining
channeling and major edits. Without punch, subsequent takes must be individually edited into
the nal channels. Using Punchkeeps a production moving forward, which boosts creativity and
productivity.
Function Buttons:
The Function buttons, labeled F1 through F8, are to be assigned custom user commands in
Cubase -> Device Setup.
Recommended custom user commands:
Input Bus
Input Gain
Input Phase
Direct Routing Assignment Mode: (Shift+ Page Up) (Nuendo only, not Cubase)
Edit routing parameters with the Encoder Knobs on their respective channels.Channel up/down to
select direct routing slots 1 to 8. Activate a direct routing slot by turning the corresponding Encoder
Knob. Enable Summing Mode on parameter page 09/09 (reached with the Channel down button)
<<<<<Utilities>>>>>
Project Utilities:
Left= XYZXYZXYZ
Right= XYZXYZXYZ
Shift
+ Left= XYZXYZXYZ
Shift
+ Right= XYZXYZXYZ
Undo = Cubase Undo function
Redo= Cubase Redo function
Shift
+ Undo = Open Undo History
Save = Save Cubase project
Shift
+ Save = Save As: Save project with a new name
Revert= ?????
Marker:
XYZXYZXYZ
Add = XYZXYZXYZ
Prev= XYZXYZXYZ
Next = XYZXYZXYZ
Shift + Add = XYZXYZXYZ
Shift + Prev = XYZXYZXYZ
Shift + Next = XYZXYZXYZ
To Next Page
Loading...
Need help?
General
