37
Click the “Download” button to upload the rmware.
Restore the factory default settings
To restore your PlatformNano settings to factory default, simply launch iMap and
import the original setting (i. e. without making any changes) to the device by the
following steps.
1. Connect PlatformNano with the provided USB cable and launch iMap software.
2. Click the “Connect” button and select “PlatformNano” as the MIDI input and
output device.
Note: If PlatformNano does not appear on the pull down menu, select USB
audio as the MIDI I/O device.
3. Click “Send Data” to upload the setting to your PlatformNano.
4. Close iMap, and then turn the PlatformNano power of off & on again.
To Next Page
Loading...
