8
Rear Panel Layout
1. USB 3. 0 port
Functions as a MIDI port to your computer and compatible software. Also
provides power to your PlatformNano.
2. User A / User B ¼ inch inputs
These¼ inch inputs are able to connect to foot pedals to activate selected
functions in your DAW. To set their parameters, select USER A and USER B
parameters in Mackie control mode.
3. 3. USB port (mini)
If your computer’s USB port is not able to provide sufcient power to drive
PlatformNano, you may connect an external power adapter (5V DC) such as
your mobile phone charger to provide extra power for the device. This is also
used to recharge your PlatformNano-M1 Wireless and power module.
(Note: Please make sure a 5V(DC) power adapter is being used (normally your
mobile phone charger is a 5V(DC) power adapter), if incorrect power voltage
adapter is used damage may caused to your device. )
4. PlatformD3 LCD module connector
Connect your optional PlatformD3 LCD module to this connector with the
provided cable.
1
1
2
43
To Next Page
Loading...
