iData 70 - Page 26

iData 70 User Manual
- 24 -
Problem
Cause
Solution
increase the storage capacity by using an
SD card.
Too many applications are
installed on the iData 70.
Remove applications installed on the iData
70.
The iData 70 does not
decode barcodes.
The scan application is not
loaded.
Load iScan in the iData 70.
Reading a barcode fails.
Check that the barcode is defective.
The battery volume is low.
If the scanner stops sending out laser beam
after you turn on the switch, check the
battery volume.