21
Installation and Servicing
SECTION 2 - INSTALLATION
2.11 MOUNTING THE BOILER - EXTERNAL
Ensure the
ue turret is
perpendicular to the
front of the boiler.
1. Fit the ue turret. Refer to Section 2.14.
2. Ensure the plastic plugs are rmoved from both the CH and DHW connections before mounting the boiler.
Note: Boiler may contain residual water.
3. Lift the boiler onto the wall mounting plate (refer to the Introduction Section for safe handling advice), locating it over the two
tabs.
Note: Install service connections at this point.
1 3
To Next Page
Loading...
