IDEAL Networks NaviTEK NT - Page 16

NaviTEK NT 153800 Iss 1
User Guide Page 16
Note that for the example of a Wiremap test shown above; if the option ‘XOver Allowed’ had
been checked in the Wiremap SETUP options, the results would be displayed as shown in Fig
16 and Fig 17.
Fig 16
Fig 17
The wiremap tests may be run with no termination – open, or with an Active Remote
termination. When connected, an image of an Active Remote will be shown on the display
and its type identified. After a test has been run, the length of the cable is displayed (range
up to 100m (330ft)).
With an open termination the possible faults detected are:
Fig 18 Open circuit by pair
Fig 19 Short circuit by pin